Woodworking circular sawing machine saw blade breakage factors
Circular sawing machine saw blade bounce teeth or loss too fast in many enterprises using metal circular sawing machine often occurs, this is a common problem, but also make the enterprise more headache, after all, the consumption of saw blade is also a considerable amount of business expenses. So is there any way to minimize this loss?
First of all, let's analyze the reasons for the damage of circular sawing machine saw blade: 1:
1. Saw blade installation is not correct
In the installation of circular sawing machine saw blade must also be correctly installed, more than a few checks, incorrect installation will not only make the metal circular sawing machine saw blade fracture will also affect the service life of circular sawing machine;
2. The amperage table is not set correctly
Incorrect amperage table settings will cause the saw blade breakage and machine damage
3. circular sawing machine cleaning work is not in place
Especially inside the iron chips, and then the small iron chips are not cleaned up in time will increase the rate of circular saw blade breakage and consumption too fast;
4. metal circular saw machine saw blade must be lightly held and lightly placed
To avoid accidentally fall on the ground to produce bump, so that the circular saw machine saw blade surface is not smooth enough, friction increased.
5. Cutting speed is too fast
Cutting speed and cutting material, for different materials cutting speed should be adjusted in a timely manner according to the requirements over, many companies in order to cut fast, blindly adjust the cutting speed, resulting in metal circular saw machine saw blade damage, which is also the fundamental reason for saw blade damage;
6. cutting material is dirty
The occurrence of this situation is relatively rare, some enterprises cutting materials are dirty, and enterprises do not pay attention to, often the material directly to the machine for cutting, never first clean up to cut the material, which is a false sense, because the material has a lot of dust, iron filings, and even dirt, etc., these are will bring a lot of friction to the metal circular saw blade cutting, friction big circular saw machine saw blade loss too fast, of course;;
7. circular saw machine working time too long at once
Usually because the enterprise in order to accelerate production, a day of work may be more than 12 hours, or even 24 hours a day machine work, this situation will make the circular saw blade cutting load increased, circular saw blade can not buffer, wear and tear too fast is inevitable;;
Related Information
How to solve the problem of bursting edges when processing plates?
2018-07-05
The plate is thicker, each piece of micro-bending is not flat, the gap between the upper and lower stacked together; mechanical pressure cylinder pressure is not enough; workpiece plate surface stripes (bump) will also burst edge; work sawing less pressure 2-3 plates; sawing plate into the knife speed is properly adjusted to slow down the appropriate cut approved; check whether the saw blade is not sharp, timely repair the edge.
How to determine whether an alloy circular saw blade needs resharpening
2018-07-05
In the sawing process, if the saw blade parts sound abnormal, rough cutting sound, or a "click, click" sound, should check the situation of the saw blade, in most cases, is a signal that needs to be repaired. Saw blade in cutting off the workpiece, its quality is basically not too much difference, the surface is relatively smooth, no burr, if you find that suddenly the surface of the workpiece is not very smooth, or the same side of the thorns, iron chips sticky workpiece does not fall off and other phenomena, you can basically judge the saw blade resharpening time to come.
Woodworking circular sawing machine saw blade breakage factors
2018-07-05
Circular sawing machine saw blade bounce teeth or loss too fast in many enterprises using metal circular sawing machine often occurs, this is a common problem, but also make the enterprise more headache, after all, the consumption of saw blade is also a considerable amount of business expenses. So is there any way to minimize this loss?