How to solve the problem of bursting edges when processing plates?
(a), appear above the burst edge
1, the main saw blade is too blunt, too few teeth;
2, the main saw blade is too little above the plate;
3, the quality of the plate is too poor, will soon blunt saw blade;
4, to replace the saw blade;
5, elevate the main saw blade;
6, the use of impurities less, high quality plate.
(B), the following burst edge (after sawing the plate)
1, the vice saw blade is too blunt;
2, the vice saw width is not enough, too narrow;
3, the main and vice saw blade centerline does not overlap;
4, to replace the saw blade;
5, change the saw blade or increase the thickness of the saw blade;
6, re-adjust the position of the vice saw left and right.
(C), there are burnt traces (after sawing on the plate)
1, the alloy saw blade is too blunt, saw blade on the saw teeth too much;
2, the speed is too high or feed too slow;
3, replace the saw blade, choose the appropriate saw blade;
(4), choose the appropriate speed of rotation and feeding speed;
(D), in the sawing with the workpiece by the sub-saw top up the phenomenon
1, the vice saw blade is too blunt;
2, the vice saw blade up too high;
3, replace the saw blade;
4, appropriate to reduce the height of the vice saw blade.
(E), the middle veneer panel burst edge
1, the plate is thicker, each piece of micro-bending is not flat, on the bottom of each other after stacking together to produce gaps;
2, mechanical compression of the cylinder pressure is not enough;
3, the workpiece plate surface stripes (bump) will also burst the edge;
4, work sawing with less pressure 2-3 pieces of plate;
5, sawing plate into the speed of the knife appropriate to slow down the appropriate cut approved;
6, check whether the saw blade is not sharp, timely repair the edge.
Related Information
How to solve the problem of bursting edges when processing plates?
2018-07-05
The plate is thicker, each piece of micro-bending is not flat, the gap between the upper and lower stacked together; mechanical pressure cylinder pressure is not enough; workpiece plate surface stripes (bump) will also burst edge; work sawing less pressure 2-3 plates; sawing plate into the knife speed is properly adjusted to slow down the appropriate cut approved; check whether the saw blade is not sharp, timely repair the edge.
How to determine whether an alloy circular saw blade needs resharpening
2018-07-05
In the sawing process, if the saw blade parts sound abnormal, rough cutting sound, or a "click, click" sound, should check the situation of the saw blade, in most cases, is a signal that needs to be repaired. Saw blade in cutting off the workpiece, its quality is basically not too much difference, the surface is relatively smooth, no burr, if you find that suddenly the surface of the workpiece is not very smooth, or the same side of the thorns, iron chips sticky workpiece does not fall off and other phenomena, you can basically judge the saw blade resharpening time to come.
Woodworking circular sawing machine saw blade breakage factors
2018-07-05
Circular sawing machine saw blade bounce teeth or loss too fast in many enterprises using metal circular sawing machine often occurs, this is a common problem, but also make the enterprise more headache, after all, the consumption of saw blade is also a considerable amount of business expenses. So is there any way to minimize this loss?